QMS CrownCopy Průvodce nastavením Strana 33

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 126
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 32
$
+$. 
7 Attach the SCSI interface card to the controller board.
a Position the SCSI interface card so that its ribbon cable
connector aligns with the SCSI connector on the controller
board.
b Gently press the ribbon cable connector down until it’s fully
seated.
Caution:
Make sure that the connectors on the ribbon cable
and the controller board are properly aligned. Damage to the
controller board could result if the pins are misaligned.
c Insert the SCSI interface card connector into its opening in
the interface panel.
5 Remove the two screws holding the
metal plate over the SCSI interface
opening.
The SCSI interface opening is labelled “SCSI.”
It’s located next to the “Serial” and “Key” ports.
You can discard the metal plate and screws.
6 Attach the ribbon cable to its connector
on the SCSI interface card.
..................
...................
..................
...................
Zobrazit stránku 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 125 126

Komentáře k této Příručce

Žádné komentáře