QMS VMS Uživatelská příručka stáhnout pdf (Strana 29)

Installing the

DECnet Host

Software

2-13

DECnet Host Software Installation

Installing the DECnet Host

Software

The QMS host software for DECnet-connected printers checks for the

presence of DECnet Phase IV or Phase V protocol and prompts your

responses accordingly.

Phase IV and Phase V Installation

The following procedure describes the installation of DECnet Phase

IV and Phase V host software. Any differences between the two

installation procedures are noted.

1 After mounting the host software media on the input device

and logging in under the system account, begin the installa-

tion program by typing this command at the host:

$ @SYS$UPDATE:VMSINSTAL↵

2 After the installation program banner, the following prompt

displays:

* Are you satisfied with the backup of your system disk?

If you’re satisfied with your backup copy of the system disk, type Y

or press Enter. Type N to exit the program if you have not made a

backup copy.

If you answered Y to the prompt, the system notifies you that it is

moving the Release Notes located on the SYS$UPDATE direc-

tory to the system help directory.

3 The installation program prompts you for the name of the

device where you have mounted the software tape:

* Where will the distribution volumes be mounted?

Type the device name and press Enter.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 117 118

Žádné komentáře

QMS VMS Uživatelská příručka Strana 29